Respironics BiPAP autoSV Advanced User Manual Page 33

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 32
User Manual
29
ChapTer 8: TroubleshooTing
is chapter describes problems that you may experience with your BiPAP autoSV device or mask and
provides possible solutions.
Problem Why It Happened What To Do
e device does not
operate when you
press the button.
If the power LED is off, there’s
no power at the outlet or the
device is unplugged. If the
power LED is on, the problem is
in the device.
Check the outlet power and verify that
the device is plugged in. If the problem
continues, call your health care professional.
e air out of the
mask is much warmer
than usual.
e inlet filters may be dirty.
e device may be operating in
direct sunlight or near a heater.
Clean or replace the inlet air filters as
described in Chapter 9. Make sure the device
is away from bedding or curtains that could
block the flow of air around the device. Make
sure the device is away from direct sunlight
and heating equipment.
If the problem persists, contact your health
care professional.
e mask feels
uncomfortable to
wear.
is could be due to
improper headgear
adjustment or improper mask
fitting.
Check the headgear adjustment as described
in the headgear instructions.
Refer to your mask instructions to make
sure the mask is properly fitted. If the
problem continues, contact your health care
professional for a refitting or a different size
mask.
ere is significant
air leakage round the
mask.
is could be due to
improper headgear
adjustment or improper mask
fitting.
Check the headgear adjustment as described
in the headgear instructions. Refer to your
mask instructions to make sure the mask is
properly fitted. If the problem continues,
contact your health care professional for a
refitting or a different size mask.
Page view 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comments to this Manuals

No comments