Respironics Solo Plus Specifications download pdf (Page 20)

ROUTINE MAINTENANCE

Cleaning and

Replacing

the Filters

CAUTION!

The gray pollen filter is a reusable filter that screens out pollens and

some household dust. This filter should be cleaned at least once every

two weeks under normal usage and replaced with a new one every six

months. One additional pollen filter is included with the System. The

pollen filter must be in place at all times when the Solo is operating.

The white ultra-fine filter increases filtration of pollens, dust, some

tobacco smoke, and other small particles. The ultra-fine filter is

included with the System, but is optional, and should be used in

addition to the pollen filter. The ultra-fine filter should never be used

without the pollen filter. Replace the ultra-fine filter after 30 nights of

use or sooner if it appears dirty. Do not clean the ultra-fine filter.

Failure to replace or clean a dirty filter may cause the Solo to

operate at higher temperatures and damage the Solo.

To change the filters:

1.Remove the pollen filter by gently pulling around the edges of the

filter. Rinse the filter in a steady stream of running water.

Squeeze out the water and repeat. Air dry on a rack for 8 to 12

hours or in a clothes dryer for 15 to 20 minutes.

2.If you are using the white ultra-fine filter, remove the ultra-fine

filter if it appears dirty and discard. Replace with a new filter.

3.Place the pollen filter over the ultra-fine filter. Insert the filters

into the filter area in the back of the Solo.

The filter must be completely dry before use. Never place a wet filter

into the Solo. We recommend that you clean the filter in the morning

and alternate using the two pollen filters provided with the System to

ensure enough drying time for the cleaned filter.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 32 33

No comments

Respironics Solo Plus Specifications Page 20