Respironics BiPAP autoSV Advanced User Manual download pdf (Page 22)

User Manual

3. Leaving a small amount of slack in the cord, connect the cord on the other side of the power supply

to one of the power inlets on the device, as shown in Figure 5–7.  e power cord has a locking

connector. To properly plug the cord in:

a. Pull the locking mechanism back.

b. Push the connector into place.

c. Release the lock.

Figure 5–7 Plugging in the AC Power Supply

NOTE: You can plug the cord into either of the power inlets on the back of the device.

4. Wrap the cord around the device’s power cord retainer, which provides strain relief for the power cord.

5. Ensure that all connections are secure.

NOTE: If you need to disconnect the power cord from the device, slide the locking connector back and

then remove the power cord.

5.5.2 USING DC POWER

You can operate the device on DC power by using the Respironics DC power adapter accessory. See the

DC power adapter instructions for more information.

CAUTION: Use only the Respironics DC power adapter available from your health care professional.

Using any other system may cause damage to the device or the vehicle.

CAUTION: When using DC power from a vehicle battery, the device should not be used while the

vehicle’s engine is running. Damage to the device or the vehicle may occur.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

No comments

Respironics BiPAP autoSV Advanced User Manual Page 22